Please see the attached article for calibrating the level sensor.


Type of printer:

  • Flashforge Creator 3
  • Flashforge Creator pro 3


Please follow the steps in the article if:

  1. Lost the instructions and need to do initial setup for the printer
  2. After replacing or upgrading hot end, level sensor as the sensors offset might change. Also applies if you have changed the build surface.
  3. Prints are not sticking to the bed, like the first layer not adhering correctly due to the bed levelling being to far from the nozzle. This method also applies if the first layers are inconsistent like gaps or uneven extrusion.
  4. Transportation or movement of the printer has shifted components .
  5. If the printer has been through heavy usage without routine maintenance.
  6. Temperature or humidity of the printers environment.