Extruders - From filament load, flow rate, to extrusio
About the cable
The thermocoupler (see Fig 1.1) is brown in colour and screws into the back of the aluminum heater block with a hex nut connector (...
Tue, 9 Aug, 2016 at 1:15 PM
Sometimes filament can get jammed in the hot end
of your 3D printer. While this is very annoying it happens to most 3D
printers from time to time.
...
Tue, 19 Jul, 2016 at 5:09 PM
What is it?
A thermocouple is the device that tells
the machine how hot the nozzle is. These can sometimes break if they
got too hot or are bumped.
...
Thu, 4 Feb, 2016 at 6:07 PM
Symptoms :
- The extruder assembly does not sit firm
- It is impossible to align left and right nozzle
- Nozzles seem to move if I push them/When bump...
Thu, 9 Jun, 2016 at 3:24 PM
If you are running the latest Flashforge firmware, version 7.2 at time of writing, you may have noticed that the unload function appears like ...
Mon, 27 Jun, 2016 at 5:43 PM
Please see the attached article for fixing some possible reason/s for under extrusion. Other Possible reasons for under-extrusion: logged or Partiall...
Fri, 18 Jul, 2025 at 4:20 PM
Please see the attached document if your problem is related to inspecting/ clearing a blockage: Some possible reasons that cause the failure to load fil...
Fri, 18 Jul, 2025 at 4:26 PM
Please see the attached file for how to put the gantry back to being square. Possible reasons for un-square gantry: Improper Assembly or Loose Screw...
Fri, 18 Jul, 2025 at 4:43 PM